Removing the Lift Cylinder (continued)
Hydraulic System: Service and Repairs
Ensure that the cutting deck is fully lowered before loosening the
hydraulic lines from the lift cylinders.
If the cutting deck is not fully lowered as the hydraulic lines are
loosened, the cutting deck may drop unexpectedly.
g293859
1.
Auxiliary control valve
2.
O-ring
3.
Lift cylinder
4.
Hose
5.
Hose
4. Disconnect the hydraulic hoses from the fittings in the lift cylinder that is to be
removed. Allow the hoses to drain into a suitable container. Remove and
discard the O-rings from the fittings.
5. Install clean caps or plugs on the hydraulic hoses and fittings to prevent
contamination.
6. Remove the nut (item 5 in
the lift cylinder to the lift arm.
7. Remove the nut (10), washers (9 and 11) and pin (12) that secures the lift
cylinder to the chassis.
8. Remove the lift cylinder from the machine.
9. If the hydraulic fittings are to be removed from the lift cylinder, mark the fitting
orientation for assembly purposes. Remove the fittings from the lift cylinder
and discard the O-rings from the fittings.
WARNING
Figure 87
6.
O-ring
7.
Bolt
8.
Bolt
9.
Breather cap
Figure
86), washer (4) and pin (1) that secures
Page 5–110
ProLine H800
19241SL Rev A