Toro ProLine H800 Service Manual page 288

Installing the Electric Clutch
Axle and PTO: Service and Repairs
1. If removed, install the drive shaft (10) onto the engine (11) and secure with
the 3 bolts (8) and washers (9).
2. Clean the drive shaft (10) and position the woodruff (7) into the drive shaft
slot.
3. Slide and install the electric clutch (6) and bushing (3) onto the drive shaft
(10).
4. Secure the electric clutch (6) with the bolt (1) and washer (2). Torque tighten
the bolt (1) to 50 N·m (36.8 ft-lb).
5. Install the PTO drive belt onto the machine; refer to Operator's Manual.
6. Check the PTO belt tension; refer to Operator's Manual.
7. Check and adjust the electric clutch gap; refer to Operator's Manual.
8. Connect the machine wire harness to the electric clutch.
Page 8–16 ProLine H800
19241SL Rev A