Toro ProLine H800 Service Manual page 187

Removing the Hopper Lift Cylinder (continued)
ProLine H800
19241SL Rev A
Before opening the hydraulic system, operate all the hydraulic
controls to release system pressure and avoid injury from the
pressurized hydraulic fluid; refer to
Hydraulic System (page
3. For assembly purposes, label all the hydraulic hoses and tubes that are
connected to the fittings on the hopper lift cylinder.
g293972
1. Bolt
2. O-ring
3. Ball joint
4. Nut
5. Hose
6. Hydraulic lift cylinder
4. Clean the hydraulic hose ends before you disconnect the hoses from the
hopper lift cylinder.
5. Disconnect the hydraulic hoses from the hopper lift cylinder.
6. Install caps or plugs on the disconnected hoses and fittings to prevent
contamination.
7. Remove the 2 snap rings (item 4 in
hopper lift cylinder (14) to the LH bracket (6).
8. Remove the nut (11) and bolt (13) that secures the hopper lift cylinder (14)
and safety handle (19 ) to the arm (7).
9. Remove the lift cylinder (14) and safety handle (19) from the machine.
10. If the hydraulic fittings are to be removed from the hopper lift cylinder, mark
the fitting orientation for assembly purposes. Remove the fittings from the
hopper lift cylinder and discard the O-rings from the fittings.
CAUTION
Releasing Pressure from the
5–5).
Figure 93
7. O-ring
8. Bolt
9. Hose
10. Hose
11. Hose
12. Auxiliary control valve
Figure
Page 5–119
92) and pin (5) that secures the
Hydraulic System: Service and Repairs