Toro ProLine H800 Service Manual page 304

Removing the Hopper Assembly (continued)
Installing the Hopper Assembly
Hopper Assembly: Service and Repairs
5. Remove the bolt (1) and washer (2) that secures the pin (3) to the machine
frame.
6. Support the hopper assembly before removing the pin (8).
7. Slide and remove the pin (3) that secures the hopper assembly to the
machine frame.
Note: Two people are required to lift the hopper assembly from the machine.
8. Lift and remove the hopper assembly from the machine.
9. If required, disassemble the hopper frame assembly as required; refer to
Disassembling the Hopper Frame Assembly (page
1. If disassembled, assemble the hopper frame assembly; refer to the
Assembling the Hopper Frame Assembly (page
2. Position the hopper assembly onto the machine. Make sure that the hopper
assembly is properly seated in its position to attach with the fasteners.
3. Apply a coat of grease to the pin (3).
4. Slide the pin (3) and secure the hopper assembly to the machine frame.
5. Secure the pin (3) with the washer (2) and bolt (1).
6. Position the hydraulic cylinders (8) onto the hopper assembly and secure
with the bolt (9) and nut (10).
7. Connect the hopper micro switch connector to the machine wire harness
connector.
8. Check and align the hopper assembly to the chute seal; refer to Operator's
Manual.
9. Lubricate the grease fittings; refer to Operator's Manual.
10. Check for correct operation of the hopper assembly and adjust the hopper
assembly sensor; refer to Operator's Manual.
Page 9–4
9–7).
9–7).
ProLine H800
19241SL Rev A