Toro ProLine H800 Service Manual page 297

Disassembling the PTO Shaft Assembly (continued)
Assembling the PTO Shaft Assembly
ProLine H800
19241SL Rev A
7. Remove the bolt (17), nut (22) and washer (21) that secures the belt tension
lever (8) to the dust flange (4). Remove the belt tension lever from the
dust flange.
8. Remove the retaining rings (1) that secures the bearings (2) and shaft (3)
into the dust flange (4).
9. Use a press to remove the bearings (2) and PTO shaft (3) from the dust
flange (4).
10. Use a press to remove the pin (18) and flange bushings (19) from the dust
flange (4).
11. If required, remove the grease fitting (20) from the dust flange (4).
12. Clean the PTO shaft (3) and dust flange (4).
13. Inspect the PTO shaft (3) and dust flange (4) for wear, pitting or other
noticeable damage. Replace the parts that are worn or damaged.
1. Apply a coat of grease to inner surfaces of bushings (19) and outer surface
of the pin (18).
2. Use a press and install the bushings (19) and pin (18) into the dust flange (4).
If removed, install the grease fitting (20) to the dust flange (4).
3. Apply anti-seize lubricant to the PTO shaft. Use a press and install the
bearings (2) and PTO shaft (3) into the dust flange (4). Secure the bearings
(2) with the 2 retaining rings (1).
4. Install the belt tension lever (8) onto the dust flange (4) and secure with the
bolt (17), washer (21) and nut (22).
5. Position the shaft key (5) onto the PTO shaft slot. Install the pulley (6) onto
the PTO shaft (3) and secure with the washer (16) and bolt (15).
6. Use a press and install the bearing (11) and bushing (9) into the pulley (12).
7. Install the pulley (12) onto the belt tension lever (8) and secure with the bolt
(7), washer (14) and nut (13).
8. Install the PTO shaft assembly onto the machine; refer to
Shaft Assembly (page 8–23).
Page 8–25
Installing the PTO
Axle and PTO: Service and Repairs