Hopper Tilt Cylinder - Toro ProLine H800 Service Manual

Hopper Tilt Cylinder

g294039
1. Hopper frame
2. Nut
3. Support
4. Bolt
Removing the Hopper Tilt Cylinder
ProLine H800
19241SL Rev A
RH Hopper Tilt Cylinder (shown)
5. Grease fitting
6. Nut
7. Hydraulic cylinder
8. Pin
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
3. For assembly purposes, label all the hydraulic connections. Clean the
hydraulic connections before loosening the hydraulic lines from the hopper
tilt cylinder.
Figure 94
10.
11.
5–63).
Page 5–121
9. Washer
Bolt
Support frame
Hydraulic System: Service and Repairs