Toro ProLine H800 Service Manual page 282

Rear Axle Housing Bushings
Axle and PTO: Service and Repairs
The rear axle steering spindle shafts must fit snugly in the rear axle. Excessive
movement of the steering spindle shaft in the axle might indicate that the flange
bushings (5) are worn or damaged and must be replaced as below:
1. Remove the rear axle from the machine; refer to
(page 8–6).
2. Use a bushing removal tool to extract the flange bushings (5) from the rear
axle (6).
Note: Take care not to damage bore of the bore during the bushing (5)
removal.
3. Clean the inside of the bore to remove all the dirt and foreign material.
4. Apply a coat of grease to the inside and outside of the new flange bushings
(5).
5. Press the bushings (5) into the rear axle (6) bore. Press the bushing (6) into
the bore until the flange shoulder bottoms on the bore.
6. Install the rear axle onto the machine; refer to
8–7).
Page 8–10
Removing the Rear Axle
Installing the Rear Axle (page
ProLine H800
19241SL Rev A