Toro ProLine H800 Service Manual page 184

Removing the Steering Cylinder (continued)
Hydraulic System: Service and Repairs
Before opening the hydraulic system, operate all the hydraulic
controls to release system pressure and avoid injury from the
pressurized hydraulic fluid; refer to
Hydraulic System (page
3. For assembly purposes, label all the hydraulic hoses and tubes that are
connected to the fittings on the steering cylinder.
4. Clean the hydraulic hose ends before you disconnect the hoses from the
steering cylinder.
g293899
1. T fitting
2. Hose
3. Fitting
4. Hose
5. Hose
6. Hydraulic control valve
7. Auxiliary control valve
5. Disconnect the hydraulic hoses from the steering cylinder.
6. Install caps or plugs on the disconnected hoses and fittings to prevent
contamination.
7. Remove the nuts (item 16 in
steering cylinder tie rod end (11) to the spindle (14 and 15).
8. Remove the 4 bolts (9), washers (10) and nuts (20) that secures the steering
cylinder (13) to the rear axle (6).
9. Remove the steering cylinder (13) from the machine.
10. If necessary, remove the tie rod end (11) from the steering cylinder (13).
11. If the hydraulic fittings are to be removed from the steering cylinder, mark
the fitting orientation for assembly purposes. Remove the fittings from the
steering cylinder and discard the O-rings from the fittings.
CAUTION
Releasing Pressure from the
5–5).
Figure 91
8. Height of cut valve
9. Fitting
10. Hose
11. Hose
12. Steering cylinder
13. O-ring
14. Fitting
Figure 90) and washers (10) that secures the
Page 5–116 ProLine H800
19241SL Rev A