Toro ProLine H800 Service Manual page 209

Testing the Fuses
ProLine H800
19241SL Rev A
1. Turn the key switch to the ON position (do not start the engine) and remove
the cap for the fuse block. With the fuse installed in the fuse block, use a
multimeter to check that 12 VDC exists at both of the terminal test points on
the fuse. If 12 VDC exists at 1 of the fuse test points but not at the other,
the fuse is damaged.
2. If necessary, remove the fuse from the fuse block for testing. The fuse should
have continuity between the fuse terminals.
A. Ensure that the key switch is in OFF position and the key is removed
from the key switch.
B. Locate the fuse(s) to be tested under the control panel.
C. Remove the fuse(s) from the fuse holder for testing. The fuse should
have continuity between the fuse terminals.
If the fuse replacement is necessary, ensure that replacement
fuse has the correct rating.
D. Replace the fuse if testing determines that it is damaged.
E. After you complete the fuse testing, install the fuse cap.
IMPORTANT
Page 6–9 Electrical System: Testing the Electrical Components