Traction Pedal - Toro ProLine H800 Service Manual

Traction Pedal

g289736
1. Washer
2. Bolt
3. Rod end
4. Traction rod
5. Linkage bellcrank
6. Grease fitting
7. Bushing
8. Nut
9. Nut
Removing the Traction Pedal
Chassis: Service and Repairs
10. Washer
11. bolt
12. Shock absorber
13. Pin
14. Bolt
15. Bolt
16. Bolt
17. Washer
18. Washer
1. Park the machine on a level surface, set the parking brake, lower the cutting
deck, shut off the engine, and remove the key from the key switch.
2. Disconnect the battery negative cable from battery terminal and then
disconnect positive cable from battery; refer to Operator's Manual.
3. For assembly purposes, label the electrical wire harness connectors.
Disconnect the machine wire harness connectors from the micro switches.
Figure 146
19.
20.
21.
22.
23.
24.
25.
Page 7–12
Bolt
Nut
Pin
Spacer
Traction pedal
Bolt
Traction pedal pin
ProLine H800
19241SL Rev A