Servicing The Rear Axle - Toro ProLine H800 Service Manual

Servicing the Rear Axle

g290147
1. Bolt
2. Washer
3. Bolt
Rear Axle Pivot Bushing
ProLine H800
19241SL Rev A
4. Nut
5. Flange bushing
6. Rear axle
The rear axle must be held in place snugly by the axle pivot pin. Excessive
movement of the axle, which is characterized by erratic steering, might indicate
worn axle pivot bushing (8). To correct the problem, replace the bushings as
below:
1. Remove the rear axle from the machine; refer to
(page 8–6).
2. Use a bushing removal tool to extract both the axle pivot bushings (8) from
the rear axle (6).
Note: Take care not to damage bore of the pivot tube during the bushing
(8) removal.
3. Clean inside of the tube to remove all the dirt and foreign material.
4. Apply a coat of grease to inside and outside of the new bushings (8).
5. Press the new bushings (8) into the rear axle (6). Bushing (6) must be flush
with the axle tube after installation.
6. Install the rear axle onto the machine; refer to
8–7).
Figure 154
Page 8–9
7. Grease fitting
8. Bushing
Removing the Rear Axle
Installing the Rear Axle (page
Axle and PTO: Service and Repairs