Shop Supplies - Toro ProLine H800 Service Manual

Shop Supplies

Anti-seize lubricant
Used to prevent corrosion, galling, and seizure between metal parts. Most often applied to shafts and
bores during assembly. Unless otherwise specified, high viscosity regular grade lithium-graphite based
anti-seize lubricant should be used.
Grease
Can be used to pre-fill (pack) bearings, boots, and seals before assembly, ease installation of
components during assembly, or fill cavities between moving parts through grease fittings after assembly.
Unless otherwise noted, refer to the machine Operator's Manual or Installation Instructions for grease
specifications.
Thread locking compound (Threadlocker)
Used to lock threaded fasteners in position. Available in low, medium, and high strength for various size
fasteners and applications. Most thread locking compounds are applied immediately before fastener
installation. Some thread locking compounds use a wicking feature, and can be applied after fastener
installation. Most thread locking compounds allow the fastener to be removed with standard tools
once cured. High strength thread locking compounds may require applying heat to the fastener and
the surrounding area to allow fastener removal.
Note: Some fasteners have a dry thread locking compound pre-applied (patch-loc) so no additional
thread locking compound is necessary when installing a new fastener. These fasteners are designed to
be removed and re-installed only once before applying additional thread locking compound is necessary.
Retaining compound (bearings and sleeves)
An adhesive used to secure bearings, bushings, and cylindrical parts into housings or onto shafts. When
cured, bearing and sleeve retaining compound fills the gap between mating parts with a hard resin that
increases load distribution and protects against corrosion.
Adhesive
Used to secure a variety of components immediately prior to assembly. May be recommended for
installing new components or when reusing a component that had a pre-applied adhesive such as
hood seals, mouldings, and weather-stripping.
ProLine H800
19241SL Rev A
The procedures found in this Service Manual may recommend the use of
commonly used shop supplies (lubricants, sealants, and adhesives). A
symbol denoting the use of a shop supply may appear in figures that support
a procedure. Always refer to the written procedure for specific information
regarding the type and the application of a shop supply.
Always follow manufacturers instructions when using or storing

shop supplies.

IMPORTANT
Page 2–13 Specifications and Maintenance: Shop Supplies
.