Differential Valve - Toro ProLine H800 Service Manual

Differential Valve

g293779
1. Nut
2. Washer
3. Differential valve solenoid
Removing the Differential Valve
ProLine H800
19241SL Rev A
4. Differential valve
5. Washer
6. Bolt
1. Park the machine on a level surface, lower the cutting deck, shut off the
engine, set the parking brake, and remove the key from the key switch.
Before opening the hydraulic system, operate all the hydraulic
controls to release system pressure and avoid injury from the
pressurized hydraulic fluid; refer to
Hydraulic System (page
2. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
3. Locate the Differential valve that is attached to front of the chassis (between
the two front wheel motors)
Figure 82
CAUTION
Releasing Pressure from the
5–5).
5–63).
(Figure 82).
Page 5–103
7. Chassis
Hydraulic System: Service and Repairs