Toro ProLine H800 Service Manual page 295

Removing the PTO Shaft Assembly
Installing the PTO Shaft Assembly
ProLine H800
19241SL Rev A
Do not start the engine and engage the PTO switch when the PTO
driveshaft is disconnected from the cutting deck. If you start the
engine and the PTO shaft is allowed to rotate, serious personal injury
and machine damage could result.
Disconnect the PTO electric clutch electrical connector whenever
the PTO driveshaft is disconnected from the cutting deck.
1. Park the machine on a level surface, lower the cutting deck, shut of the
engine, set the parking brake and remove the key from the key switch.
2. Remove the PTO driveshaft from the machine; refer to
Driveshaft (page 8–18).
3. Remove the PTO drive belt from the machine; refer to Operator's Manual.
4. Remove the cotter pin (32) and pin (33) that secures the fork (31) to the belt
tension lever (7). Separate the fork (31) from the belt tension lever (7).
5. Support the PTO shaft assembly (4) to prevent from falling.
6. Remove the nuts (39), washers (40 and 41) and bolts (42) that secures the
PTO shaft assembly (4) to the chassis. Carefully remove the PTO shaft
assembly (4) from the machine.
7. Disassemble the PTO shaft assembly; refer to
Assembly (page 8–24).
1. If disassembled, assemble the PTO shaft assembly; refer to
PTO Shaft Assembly (page
2. Carefully position the PTO shaft assembly (4) onto the chassis.
3. Secure the PTO shaft assembly (4) onto the chassis with bolts (42), washers
(41 and 40) and nuts (39).
4. Position the fork (31) onto the belt tension lever (7) and secure with the pin
(33) and cotter pin (32).
5. Install the PTO drive belt to the machine; refer to Operator's Manual.
6. If necessary, adjust the PTO clutch gap; refer to Operator's Manual.
7. Check and adjust the PTO belt tension; refer to Operator's Manual.
8. Install the PTO driveshaft to machine; refer to
(page 8–19).
WARNING
8–25).
Page 8–23
Removing the PTO
Disassembling the PTO Shaft
Assembling the
Installing the PTO Driveshaft
Axle and PTO: Service and Repairs