Toro ProLine H800 Service Manual page 199

Removing the Oil Cooler
Inspecting the Oil Cooler
Installing the Oil Cooler
ProLine H800
19241SL Rev A
g289054
1. Oil cooler
2. Nut
3. Bolt
4. Washer
The radiator and oil cooler must be removed from the machine as an assembly;
refer to Removing the Radiator (page
1. Back flush the oil cooler with cleaning solvent. After cleaning the cooler,
ensure that all the solvent is drained from the cooler.
Use an eye protection such as goggles when using the compressed
air to dry the oil cooler.
2. Use the compressed air in the opposite direction of the fluid flow and dry
the interiors of the oil cooler.
3. Install the clean plugs on the oil cooler ports. Clean the outer surface of
the cooler.
Note: The oil cooler must be free from corrosion, cracked tubes, or excessive
pitting of tubes.
The radiator and oil cooler must be installed into the machine as an assembly;
refer to Installing the Radiator (page
Figure 101
5. Bracket
6. Hydraulic hose
7. Hydraulic hose
4–8).
WARNING
4–10).
Page 5–131 Hydraulic System: Service and Repairs