Toro ProLine H800 Service Manual page 267

Removing of Brake Pedal
Installing the Brake Pedal
ProLine H800
19241SL Rev A
1. Park the machine on a level surface, set the parking brake, lower the cutting
deck, shut off the engine, and remove the key from the key switch.
2. Block the wheels with chocks to prevent the machine from moving.
3. Disconnect the battery negative cable from battery terminal and then
disconnect positive cable from battery; refer to Operator's Manual.
4. Disconnect the electrical wire harness connector from the parking brake
switch.
5. Disassemble the brake pedal as needed using the
1. Apply a coat of grease on outer diameter of the brake pedal pin (29) and
inner diameter of the bushing (1).
2. Assemble the brake pedal using the
3. After the brake pedal assembly, make sure that there is no binding in
pedal movement and also that pedal returns to the centered position when
released. Correct any sticking or binding before the machine operation.
4. Plug the machine wire harness connectors into the parking brake micro
switch.
5. After assembly of the brake pedal, adjust the brake pedal; refer to Operator's
Manual. Make sure that the brake pedal does not contact anything through
both forward and reverse directions.
6. Connect positive battery cable from battery terminal and then connect
negative cable to battery; refer to Operator's Manual.
Figure 147
Page 7–15
Figure 147 as a guide.
as a guide.
Chassis: Service and Repairs