Seat Switch
g289939
1.
Bellows
2.
Spring pack
3.
Seat level indicator housing
4.
Cover
5.
Switch plate
Testing the Seat Switch
Electrical System: Testing the Electrical Components
6.
Cable ties
7.
Blind rivet
8.
Seat switch with cable
9.
Bushing
10.
Compression springs
The seat switch normally open and closes when the operator is on the seat. If
the traction system or PTO switch is engaged when the operator raises out of
the seat, the engine shuts off. The seat switch and its electrical connector are
located directly under the seat. Testing of the switch can be done without seat
removal by disconnecting the seat wire from the machine wire harness.
The Electronic Control Unit (ECU) monitors the operation of the seat switch.
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, and shut off the engine.
2. Ensure that the key switch is in the OFF position. Locate the switch for
testing.
Figure 123
11.
12.
13.
Page 6–26
Blind rivet
Switching bracket
Backrest frame
ProLine H800
19241SL Rev A