Operator Presence Switch (Seat Switch) - Toro TITAN Max Service Manual

Hour Meter Status Check (continued)

Operator Presence Switch (Seat Switch)

Operator Presence Switch (Seat Switch) Test
Electrical System: Service and Repairs
g336418
With the ignition switch in the RUN position, and the operator presence switch
closed (operator is in the seat), battery voltage is supplied to the neutral switches.
Note: The operator presence switch is part of the seat assembly.
g336419
1. Disconnect the wire harness from the operator presence switch, located
on the bottom of the seat assembly.
2. Using a digital multi-meter set to the OHM or continuity setting, test the
continuity between the two switch terminals.
• When the seat is vacated, the switch should NOT have continuity (open).
• When the operator is present, the switch should have continuity (closed).
Figure 109
Figure 110
Page 8–6 TITAN® Max Service Manual
3442-428 Rev A