Seat Switch - Toro Reelmaster 3100-D Service Manual

Seat Switch

g346743
1. Seat bottom
2. Seat belt kit
Testing
Electrical System: Component Testing
3. Seat switch
4. Seat back
The seat switch is normally open and closes when the operator is on the seat. If
the traction system or PTO switch is engaged when the operator raises out of the
seat, the engine shuts off. The seat switch and its electrical connector are located
directly under the seat
seat removal by disconnecting the seat wire from the machine wire harness.
The Standard Control Module (SCM) monitors the operation of the seat switch.
If the key switch is in the ON position and the seat is occupied, the SCM in
seat input LED should be illuminated.
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, and shut off the engine.
2. Before you disconnect the seat switch for testing, ensure that you test the
switch and its circuit wiring as a SCM input; refer to
(SCM) (page 6–45).
3. If the SCM verifies that the seat switch and circuit wiring are functioning
correctly, no further switch testing is necessary.
4. If the SCM determines that the seat switch and circuit wiring are not
functioning correctly, proceed with the following switch testing procedure.
Figure 125
(Figure 124). Testing of the switch can be done without
Page 6–20
5. Flange head screws
6. Decal
Standard Control Module
Reelmaster ®
20252SL Rev A
3100-D/3105-D