Operator Presence Switch (Seat Switch) - Toro Z MASTER 2000 Series Service Manual

Hourmeter Test (continued)

Operator Presence Switch (Seat Switch)

Operator Presence Switch (Seat Switch) Test
2000 Series Z MASTER® Service Manual
3438-778 Rev A
g336418
With the ignition switch in the RUN position, and the operator presence switch
closed (operator is in the seat), battery voltage is supplied to the neutral switches.
Note: The operator presence switch is part of the seat assembly.
g336419
1. Disconnect the wire harness from the operator presence switch, located
on the bottom of the seat assembly.
2. Using a digital multi-meter set to the OHM or continuity setting, test the
continuity between the two switch terminals.
• When the seat is vacated, the switch should NOT have continuity (open).
• When the operator is present, the switch should have continuity (closed).
Figure 84
Figure 85
Page 8–7 Electrical: Service and Repairs