Installing A Cabinet Lower Mounting Kit - Huawei FusionModule5000 Series Installation Manual

FusionModule5000 Smart Modular Data Center
Installation Guide (Single-Row Aisle Containment with
2000 mm High Cabinets, ECC800)
No.

6.3.1 Installing a Cabinet Lower Mounting Kit

Context
Cabinet lower mounting kits are required only when 2000 mm high cabinets are placed at one
or both ends of an aisle containment, and can be obtained from the end door fitting bag.
Cabinet lower mounting kits are used to seal the bottom of a 2000 mm high cabinet placed at
the end of an aisle containment, and consist of five components, as shown in
Figure 6-12 Assembled cabinet lower mounting kits
(1) Side sealing plate
Procedure
Step 1 Take the six components of the aisle door fittings out of the end door fitting bag, and
assemble four of them into front and real sealing plates with the same width as the cabinet, as
shown in
Issue 01 (2019-03-05)
Check Item
within 3 mm, and no deviation is preferred.
The front and rear sealing plates are each assembled by two components. The length after assembly can
be 600 mm or 800 mm.
Figure 6-13.
 (1) in Figure 6-13 shows the individual front and rear sealing plates.
 (2) in Figure 6-13 shows the assembled front and rear sealing plates for 600 mm wide cabinets.
 (3) in Figure 6-13 shows the assembled front and rear sealing plates for 800 mm wide cabinets.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Installing the Contained Aisles
(2) Front or rear sealing plate
Result
□ Incompliant
Figure 6-12.
87