Huawei FusionModule5000 Series Installation Manual page 191

FusionModule5000 Smart Modular Data Center
Installation Guide (Single-Row Aisle Containment with
2000 mm High Cabinets, ECC800)
Figure 12-18
Figure 12-18 Ports on the SMS modem
(1) Connecting to the SIM card
(3) Connecting to the power cable
Procedure
Step 1 Install a SIM card for the modem.
Use a tool such as the small screwdriver to press the yellow key. Put the SIM card on the
ejected tray, and insert the tray into the SMS modem.
Step 2 Attach the antenna (BOM number: 27010824) to the skylight connective plate or the top plate
of the network cabinet outside the contained aisle. Connect the antenna cable to the antenna
port on the modem.
Step 3 Connect the serial cable.
Connect a cable from the modem to an idle serial port on the server. For the position of the
serial port, see the documents delivered with the server.
Step 4 Connect the power cable.
Use the power adapter delivered with the modem.


After connecting the power cable, switch on the power supply. The modem indicator should
blink regularly.
modem status.
Issue 01 (2019-03-05)
shows the ports on the SMS modem.
Do not use the antenna delivered with the modem.
For the connection method, see the documents delivered with the modem.

If the serial port on the server does not match the connector of the serial cable, use the serial cable

adapter delivered with the modem.
Connect one end of the power adapter to the modem. For the connection method, see the
documents delivered with the modem.
Connect the other end of the power adapter to the 220 V power supply through a power
connector (BOM number: 14190143).
Table 12-2 describes the relationships between the indicator status and the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(2) Connecting to the antenna
(4) Serial port
12 Cable Routing
182