Huawei FusionModule5000 Series Installation Manual page 128

FusionModule5000 Smart Modular Data Center
Installation Guide (Single-Row Aisle Containment with
2000 mm High Cabinets, ECC800)
Figure 9-12 Installing a SIM card
3. Reinstall the ECC800 main control module in the ECC800 subrack, and tighten the
captive screws on both sides of the module.
Step 5 Install the antenna.
1. The antenna can be installed using the magnet on its base. Attach the 2.4G antenna
(RF_Z antenna) to the skylight connective plate above the top of the network cabinet in
the aisle containment. (Optional) Attach the 3G antenna to the skylight connective plate
or the network cabinet top plate outside the aisle containment, as shown in
2. Route the 2.4G antenna cable through the cable hole in the skylight plate, through the
rodent-proof mesh and sponge strip on the top of the cabinet, and into the correct port on
the ECC800. (Optional) Route the 3G antenna cable through the rodent-proof mesh and
sponge strip on the top of the cabinet and into the correct port on the ECC800, as shown
in
Figure 9-13 Installing an antenna
(1) 2.4G antenna
3. Connect the 2.4G antenna cable to the RF_Z antenna port on the ECC800. (Optional)
Connect the 3G antenna cable to the 3G/4G antenna port on the ECC800, as shown in
Figure
Issue 01 (2019-03-05)
Figure 9-13.
9-14.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Installing Monitoring Devices
(2) 3G antenna
Figure 9-13.
119