Huawei FusionModule5000 Series Installation Manual page 145

FusionModule5000 Smart Modular Data Center
Installation Guide (Single-Row Aisle Containment with
2000 mm High Cabinets, ECC800)
Figure 9-38 Installing the magnet
(1) White rubber washer
Step 7 (Optional) Adjust the magnet.
If the magnet does not work properly after power-on, check that:
1. The magnet provides magnetic force by attaching magnetizable iron parts to it.
2. The revolving door magnetic lock is aligned with the magnet face-to-face.
3. No gap exists between the revolving door magnetic lock and the magnet.
If any of the preceding conditions is not met, the magnetic lock fails to attract the magnet.
Troubleshoot the magnet as follows:
1. Check the circuit and rectify any circuit fault.
2. Adjust the magnet base and the door panel to align the magnetic lock with the magnet
face-to-face. Ensure that the deviation is minimum.
3. If a gap exists between the revolving door magnetic lock and the magnet, rectify the fault
as shown by (1) in
4. If the magnet is not level, use a spacer shown by (2) in
levelness.
Issue 01 (2019-03-05)
Figure 9-39.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Installing Monitoring Devices
Figure 9-39 to adjust the magnet
136