Huawei FusionModule5000 Series Installation Manual page 152

FusionModule5000 Smart Modular Data Center
Installation Guide (Single-Row Aisle Containment with
2000 mm High Cabinets, ECC800)
Figure 9-45 Installing an IC card reader
Step 2 Secure the baffle plate with the cable hole in the middle to the pad mounting kit using the M4
nuts, spring washers, and flat washers, as shown by (2) in
Keep the protruding plane of the baffle plate flush with the end plane of the pad mounting kit.
Step 3 Remove the screws from the IC card reader cover (set aside) and take off the cover, as shown
by (3) and (4) in
Step 4 Route the IC card reader cable through the cable hole in the baffle plate, as shown by (5) in
Figure
Step 5 Keep the screw holes of the cover at the bottom and use two M3x8 screws to secure the IC
card reader to the baffle plate, as shown by (6) in
Step 6 Secure the cover to the IC card reader, as shown by (7) and (8) in
After the IC card reader has been installed properly, reinstall the cover on the card reader
immediately. Otherwise, the card reader will trigger an alarm after it is powered on.
----End
Issue 01 (2019-03-05)
Figure 9-45.
9-45.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Installing Monitoring Devices
Figure 9-45.
Figure 9-45.
Figure 9-45.
143