Huawei FusionModule5000 Series Installation Manual page 138

FusionModule5000 Smart Modular Data Center
Installation Guide (Single-Row Aisle Containment with
2000 mm High Cabinets, ECC800)
Table 9-1 Mapping between the names and BOM numbers of monitoring actuators and converters
Name
AC actuator
Access
actuator
WiFi
converter
Skylight
actuator
Procedure
Step 1 Remove the fastener, remove M4 screws, and take off the rear plate, as shown in
Figure 9-27 Removing the rear plate from the upper frame mounting kit
Step 2 Install the WiFi converter onto the guide rail. Determine the installation position for the WiFi
converter based on the label on the upper frame mounting kit. Align the upper slot on the rear
mounting kit of the WiFi converter with the upper part of the guide rail and then press the
lower part of the converter to clamp the lower slot of the converter to the guide rail, as shown
in Figure
installed.
Issue 01 (2019-03-05)
BOM
Number
52271876
52271874
50100888
52271875
9-28. Shake the WiFi converter in different directions to check that it is securely
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Install it at the upper frame mounting kit for the PDC in
the smart module.
Install it at the upper frame mounting kit for the PDC or
network cabinet in the smart module.
Install it at the upper frame mounting kit for the PDC in
the smart module. Use it with the WiFi antenna (BOM
number: 27012015).
If one skylight actuator is configured, install it in the
upper frame mounting kit for the network cabinet in the
smart module. If two skylight actuators are configured,
install them in the upper frame mounting kits for the
front and rear end doors respectively.
9 Installing Monitoring Devices
Figure 9-27.
129