•
RESTRAINT SYSTEMS
8M - 7
D R I V E R ' S
SIDE
REMOVAL
(1) Disconnect negative cable from battery and iso
late.
(2) Remove plastic retainers holding rubber air
dam to radiator support on driver's side.
(3) Working through air dam opening remove 3
screws holding sensor to front wheelhouse extension.
Remove sensor (Fig. 7).
• Do not remove tape holding harness to con
nector.
(4) Unplug connector from sensor and remove sen
sor (Fig. 6).
INSTALLATION
(1) Connect sensor wiring lead from harness to
connector on body of sensor.
(2) Mount sensor (arrow pointed forward) using 3
screws provided with new sensor. Torque screws to 4
to 5 N-m (35 - 45 in. lbs.).
(3) Install rubber air dam across opening.
(4) Do not connect negative battery cable. Refer to
Airbag Systems Check for proper procedure.
IMPACT SENSORS—V-10 AND DIESEL ENGINES
WARNING: B E F O R E BEGINNING ANY AIRBAG S Y S
TEM REMOVAL OR INSTALLATION P R O C E D U R E S ,
R E M O V E AND ISOLATE T H E B A T T E R Y NEGATIVE
(-) C A B L E FROM T H E V E H I C L E BATTERY. THIS IS
T H E ONLY S U R E WAY TO D I S A B L E T H E AIRBAG
S Y S T E M . F A I L U R E T O DO THIS C O U L D R E S U L T IN
ACCIDENTAL A I R B A G D E P L O Y M E N T AND P O S S I
B L E P E R S O N A L INJURY.
A L L O W S Y S T E M
CAPACITOR
T O D I S C H A R G E
FOR 2 MINUTES B E F O R E BEGINNING COMPONENT
REMOVAL.
The impact sensors are located on the inner
fender extensions behind the grille opening re
inforcement.
PASSENGER
SIDE
REMOVAL
(1) Disconnect negative cable from battery and iso
late.
(2) Remove 3 screws holding sensor to front wheel-
house extension. Remove sensor (Fig. 5).
Do not remove tape holding harness to con
nector.
(3) Unplug connector from sensor and remove sen
sor (Fig. 6).
INSTALLATION
(1) Connect sensor wiring lead from harness to
connector on body of sensor.
(2) Mount sensor (arrow pointed forward) using 3
screws provided with new sensor. Torque screws to 4
to 5 N-m (35 - 45 in. lbs.).
(3) Do not connect negative battery cable. Refer to
Airbag Systems Check for proper procedure.
D R I V E R ' S S I D E
REMOVAL
(1) Disconnect negative cable from battery and iso
late.
(2) Remove 2 battery holddown bolts (Fig. 8).
Fig. 8 Battery
Holddown
(3) Pull up on battery heatshield (if equipped) to
remove i t (Fig. 9).
(4) Remove battery from vehicle.
(5) From under left front wheel opening remove 2