8D - 24
IGNITION SYSTEMS
•
• I f the lamp flashes 3 times, pauses and flashes 5
more times, a flashing Diagnostic Trouble Code
(DTC) number 35 is indicated.
After any stored DTC information has been ob
served, the display will end with a flashing DTC
number 5 5 . This will indicate the end of all stored in
formation.
ERASING T R O U B L E
CODES
After the problem has been repaired, the DRB scan
tool must be used to erase a DTC. Refer to the ap
propriate Powertrain Diagnostic Procedures service
manual for operation of the DRB scan tool.
COMPONENT REMOVAL/INSTALLATION
INDEX
page
Automatic Shut Down (ASD) Relay
24
Camshaft Position Sensor—3.9L V-6 or 5.2/5.9L V-8
Engines
24
Camshaft Position Sensor—8.0L V-10 Engine
. . . . 25
Crankshaft Position Sensor—3.9L V-6 or 5.2/5.9L
V-8 Engines
26
Crankshaft Position Sensor—8.0L V-10 Engine
. . . 27
Distributor Service .
29
Engine Coolant Temperature Sensor
28
General Information
24
GENERAL INFORMATION
This section of the group, Component Removal/In
stallation, will discuss the removal and installation
of ignition system components.
For basic ignition system diagnostics and service
adjustments, refer to the Diagnostics/Service Proce
dures section of this group.
For system operation and component identification,
refer to the Component Identification/System Opera
tion section of this group.
AUTOMATIC SHUT DOWN (ASD) RELAY
The automatic shut down (ASD) relay is located i n
the power distribution center (PDC). The PDC is lo
cated next to the battery i n the engine compartment
(Fig. 1). For the location of the relay within the PDC,
refer to PDC cover.
REMOVAL
(1) Disconnect negative battery cable at battery.
(2) Remove the cover at PDC.
(3) Remove the relay from the PDC by pulling
straight up.
INSTALLATION
(1) Check the relay terminals i n the PDC connec
tor for corrosion or damage before installing relay.
Repair as necessary.
(2) Push the relay into the connector on the PDC.
(3) Connect negative battery cable at battery.
page
Ignition Coil Packs—8.0L V-10 Engine
31
Ignition Coil—3.9L V-6 or 5.2/5.9L V-8 Engines
. . . 30
Ignition Control Module—8.0L V-10 Engine
. . . . . . 32
Intake Manifold Air Temperature Sensor . . . . . . . . . 32
Manifold Absolute Pressure (MAP) Sensor
33
Oxygen Sensor (02S)
33
Powertrain Control Module (PCM)
33
Spark Plug Secondary Cables
34
Spark Plugs
33
Throttle Position Sensor (TPS)
35
Fig.
1 Power Distribution
Center
(PDC)
CAMSHAFT POSITION SENSOR—3.9L V-6 OR
5.2/5.9L V-8 ENGINES
The camshaft position sensor is located in the dis
tributor (Fig. 2).
REMOVAL
Distributor removal is not necessary to remove
camshaft position sensor.
(1) Disconnect negative battery cable at battery.
(2) Remove the air cleaner assembly and connect
ing air tubes.