Chrysler RAM TRUCK 2500 1994 Service Manual page 448

•
HORNS 8G - 3
(5) Remove 4 nuts attaching airbag module (Fig.
4).
J948G-2
Fig. 4 Airbag Module Removal
(6) Remove airbag module from steering wheel.
There are 2 l o c k i n g tabs h o l d i n g h o r n b u t t o n
to steering wheel (Fig. 5).
LOCKING
TABS
J948G-4
Fig. 5 Horn Button Locking Tabs
(7) Using a small screwdriver pry horn button
from steering wheel (Fig. 6).
(8) Unplug electrical connectors and remove horn
buttons from steering wheel (Fig. 7).
Fig. 6 Horn Button Removal
HORN
CIRCUIT
.CONNECTORS
J94SG-S
Fig. 7 Horn Button Connectors
INSTALLATION
(1) Connect electrical leads to horn button termi­
nals.
(2) Snap horn buttons into place i n steering wheel.
(3) Position airbag module into place on steering
wheel. Install attaching nuts and tighten to 1.5 N*m
(15 in. lbs.).
(4) Install right rear steering wheel cover.
(5) Plug electrical connector to speed control
switches.
(6) Install speed control switches with 2 screws.
HORN REPLACEMENT
The horn(s) is/are located on the driver's side
bumper support (Fig. 8).
(1) Raise vehicle.
(2) Disconnect horn(s) electrical connector.