8A - 14
ELECTRICAL
•
SOLENOID
TESTING
Refer to Group 8B - Battery/Starter/Generator Ser
vice for starter removal procedures.
(1) Disconnect field coil wire from field coil termi
nal (Fig. 9).
Fig. 9 Field Coil Wire Terminal
(2) Check for continuity between solenoid terminal
and field coil terminal with a continuity tester. There
should be continuity (Fig. 10).
(3) Check for continuity between solenoid terminal
and solenoid housing. There should be continuity
(Fig. 11).
(4) I f there is continuity, solenoid is good. I f there
is no continuity i n either test, solenoid has an open
circuit and is defective. Replace the starter motor.
(5) Install starter as described i n Group 8B - Bat
tery/Starter/Generator Service.
Fig. 10 Continuity Test Between Solenoid
Terminal
and Field Coil Terminal
SOLENOID
RR8BD33
Fig. 11 Continuity Test Between Solenoid
Terminal
and Solenoid
Housing
(6) Connect field coil wire to field coil terminal
(Fig. 9).
PARK/NEUTRAL
POSITION
SWITCH
Refer to Group 21 - Transmissions for diagnostic
information.
CLUTCH
SWITCH
Refer to Group 6 - Clutch for diagnostic informa
tion.