Chrysler RAM TRUCK 2500 1994 Service Manual page 845

9 - 124 5.9L (DIESEL) ENGINE
•
J9409-53
Fig. 3 Engine Front Mounts
E N G I N E
SUPPORT
BRACKET/
C U S H I O N
BRACKET J9409-122
Fig. 4 Positioning Engine Front Mounts
(4) Install thru-bolt nuts and tighten the nuts to
150 N-m (110 ft. lbs.) torque.
(5) Lower the vehicle.
(6) Remove lifting fixture.
ENGINE REAR MOUNT
REMOVAL
(1) Raise the vehicle on a hoist.
(2) Position a transmission jack i n place.
(3) Remove support cushion stud nuts (Fig. 5).
(4) Raise rear of transmission and engine
SLIGHTLY.
(5) Remove the bolts holding, the support cushion
to the transmission support bracket. Remove the sup­
port cushion.
(6) I f necessary, remove the bolts Holding the
transmission support bracket to the transmission
(Fig.
6).
Fig. 5 Engine Rear Support Cushion
Fig. 6 Transmission Support Bracket
INSTALLATION
(1) I f removed, position the transmission support
bracket to the transmission. Install new attaching
bolts and tighten to 88 N-m (65 ft. lbs.) torque.
(2) Position support cushion to transmission sup­
port bracket. Install stud nuts and tighten to 41 N-m
(30 ft. lbs.) torque.
(3) Using the transmission jack, lower the trans­
mission and support cushion onto the crossmember
(Fig. 5).