•
OVERHEAD CONSOLE
8C - 9
Fig. 1 Ambient
Temperature
Sensor.
(2) Remove screw attaching sensor and bracket.
(3) Unplug electrical connector.
(4) To install new sensor, reverse removal proce
dures. Tighten attaching screw to 5.5 N-m (50 in.
lbs.) torque.
CONSOLE REPAIR PROCEDURES
REMOVAL
(1) Remove 2 console mounting screws (Fig. 2).
J948G5
Fig. 2 Remove
Console
Mounting
Screws'
(2) Pull front of console down slightly then move i t
rearward until mounting clips detach from roof panel
(Fig. 3).
Fig. 3 Remove/Install
Overhead
Console
(3) Disconnect wire harness from compass module.
INSTALLATION
(1) Connect wire harness to compass module.
(2) While locating front edge of console to indenta
tion of headliner, install 2 screws.
(3) Push up on console housing adjacent to each
reading/courtesy lamp lens until the mounting lips
are felt to seat into position.
COMPASS MODULE REPLACEMENT
(1) Remove overhead console and disconnect wir
ing. Refer to Console Repair Procedures.
(2) Remove 3 screws holding compass module to
console (Fig. 4).
(3) Unplug harness connector from lighting module
(Fig. 5).
(4) Remove compass module.
(5) For installation, reverse the removal proce
dures.
LENS/LAMP REPLACEMENT
(1) Insert a long flat blade tool at the notch on the
curved edge of the lens. Carefully pry the lens from
the housing and pivot the lens down. Slide lens side
ways, away from center of console, to disengage lens
pivots.
(2) Remove bulb by pulling straight down.
(3) Install new bulb by pushing firmly into socket.