Chrysler RAM TRUCK 2500 1994 Service Manual page 468

•
TURN SIGNALS AND HAZARD WARNING FLASHER 8J - 3
VIEW FROM TERMINAL CASE
SWITCH POSITIONS
TURN SIONAl HAZARD WARNING CONTINUITY BETWEEN
NEUTRAL OFF
12 AND 14 AND 15
LEFT
LEFT
LEFT
OFF
OFF
OFF
15 AND 16 AND 17
12 AND 14
22 AND 23 WITH OPTIONAL CORNER LAMPS
RIGHT
RIGHT
RIGHT
OFF
OFF
OFF
11 AND 12 AND 17
14 AND 15
23 AND 24 WITH OPTIONAL CORNER LAMPS
NEUTRAL
ON 11 AND 12 AND 13 AND 15 AND 16
908J-4
Fig. 4 Turn Signal and Hazard Switch Continuity Chart
MULTI-FUNCTION SWITCH S E R V I C E P R O C E D U R E S
REMOVAL
(1) Disconnect negative cable from battery.
(2) Remove tilt lever (tilt column only).
(3) Remove both upper and lower steering column
covers.
(4) Remove multi-function switch tamper proof
mounting screws (tamper proof torx bit Snap On
TTXR20B2 or equivalent required).
(5) Gently pull switch away from column. Loosen
connector screw. The screw will remain i n the con­
nector.
(6) Remove wiring connector from multi-function
switch (Fig. 5).
INSTALLATION
(1) Install wiring connector to switch and tighten
connector retaining screw to 2 N-m (17 in. lbs.)
torque.
(2) Attach multi-function switch to column and
torque retaining screws to 2 N-m (17 in. lbs.).
(3) Install steering column covers. Torque retaining
screws to 2 N-m (17 in. lbs.).
HAZARD WARNING
908J-9
Fig. 5 Multi-Function Switch
(4) Install tilt lever (tilt column only).
(5) Install negative cable to battery.
(6) Check all functions of switch for proper opera­
tion.