INSTRUMENT PANEL AND GAUGES
8E - 21
Fig. 5 Knee Blocker
Remowal
PUSH TAB
UP
STEERING
C O L U M N
J948E-4
Fig. 6 PRND21 Cable
Removal
J948E-11
Fig. 7 Instrument Cluster
Removal
(8) Remove cluster.
INSTALLATION
(1) Connect 2 large connectors to cluster.
(2) Position cluster to instrument panel and install
4 screws.
INSTRUMENT CLUSTER
J948E-12
Fig. 8 Unplug Electrical
Connectors
(3) I f equipped, connect PRND21 actuator to steer
ing column.
(4) Place shift selector i n PARK position. Indicator
should be properly positioned. I f not, adjust indicator
by turning recessed hex head (9/64-inch hex key
wrench) underneath cable retainer (Fig. 9).
INDICATOR
PRND21 SCREW
ADJUSTING
J948E-66
Fig. 9 PRND21 Indicator
Adjustment
(5) Install knee blocker.
(6) Plug connectors onto cigar lighter and auxiliary
power outlet attached to bezel.
(7) Install bezel.
(8) Install cup holder and ash receiver assemblies.
Be certain that center clips on metal track housings
catch tabs on instrument panel. Tighten screws to
2.2 N-m (20 in. lbs.) torque.
(9) Connect negative cable to battery.
(10) Check to see that all instruments are func
tioning properly.
PRINTED CIRCUIT BOARD
REMOVAL (FIGS.
10 AND 11)
(1) Remove instrument cluster. See cluster re
moval.
(2) Remove lamp socket assemblies.
(3) Remove gauge mounting screws and remove
gauges.
(4) Remove low fuel warning circuit connector, i f
equipped.
(5) Remove printed circuit board from cluster hous
ing.