•
LAMPS
8L -
9
LICENSE PLATE LAMP PANEL
REMOVAL (FIG. 8)
(1) Remove screws holding license plate panel to
cargo box.
(2) Disengage license plate lamp wire connector
from body wire harness.
(3) Separate license plate lamp from vehicle.
INSTALLATION
Reverse the preceding operation.
LICENSE
PLATE
LAMP
Fig. 8 License
Plate Lamp Panel
LAMP S Y S T E M S
DAYTIME RUNNING LAMPS—CANADA ONLY
The daytime running lamps are controlled by the
Daytime Running Lamp Relay (DRLR). The DRLR is
located i n the engine compartment on the left fender
wheelhouse (Fig. 9). The DRLR allows the high beam
headlamps to illuminate at 50% of the switched ON
brightness when the engine is running with the
headlamp switch OFF. The Daytime running lamps
will go out when the headlamp switch is pulled out.
The passing light feature will flash bright high
beams while the daytime running lamps are acti
vated.
DAYTIME RUNNING LAMP
DIAGNOSTICS
The daytime running lamp system shears fuse 24,
in the fuse panel, with the back-up lamp circuit. The
DRLR is controlled by inputs received from the
Speed Sensor, Headlamp Switch and the Engine Con
troller (SBEC). Refer to Group 8W, Wiring Diagrams
for component location and circuit information.
DAYTIME R U N N I N G LAMP
RELAY
REMOWAL
(FIG.
9)
(1) Release hood latch an open hood.
(2) Disconnect wire connector from DRLR.
(3) Remove screw holding DRLR to engine com
partment dash panel.
(4) Separate DRLR from dash panel.
INSTALLATION
Reverse the preceding operation.
Fig. 9 Daytime Running Lamp Relay
(DRLR)