Chrysler RAM TRUCK 2500 1994 Service Manual page 934

•
BUMPERS AND FRAME 13 - 21
(4) Separate the switch cover from the housing
(Fig. 18).
(5) Detach the lamp holders from the switch cover.
Disconnect the wire harness connectors from the
switches (Fig. 18).
(6) Remove the nut, ring washer and lock washer
from each toggle switch (Fig. 18).
(7) Remove the toggle switches from the switch
cover (Fig. 18).
(8) Carefully pry the auxiliary headlamp switch
outward from the switch cover face. Remove it from
the switch cover (Fig. 18).
ASSEMBLY/INSTALLATION
(1) Insert the auxiliary headlamp switch in the
switch cover opening. Carefully push inward until it
is completely seated against the cover face (Fig. 18).
(2) Position the toggle switches in the switch cover
openings. Install the lock washers, ring washers and
nuts (Fig. 18). Tighten the nuts with 5 N-m (45 in.
lbs.) torque.
(3) Insert the lamp holders in the switch cover
openings. Connect the wire harness connectors to the
switches (Fig. 18).
(4) Mate the switch cover with the module hous­
ing. Install the housing attaching screws (Fig. 18).
Tighten the screws until the screw heads are seated
against the housing.
(5) Position the control module on the instrument
panel with the slots aligned with the holes. Install
the retainers and screws (Fig. 17). Tighten the
screws until the module is tightly attached to the in­
strument panel.
INSTRUMENT
PANEL
WIRE
HARNESS
AUXILIARY
HEADLAMP
SWITCH
BLADE
RAISE/LOWER
SWITCH
RETAI N ER
SWITCH
COVER AND BEZEL
HOUSING
BLADE
ANGLE
SWITCH
J9123-424
Fig. 17 Snow Plow Control Module Removal/
Installation