Chrysler RAM TRUCK 2500 1994 Service Manual page 932

•
B U M P E R
S AND FRAME 1
RB534
Fig. 13 Crossover Relief Valve—Disassembled
POWER ANGLING CYLINDER SERVICE
I f angling cylinder fluid leakage occurs, the cause
could be a loose gland nut (Fig. 14). Tighten the
gland nut.
CAUTION; Over-tightening the gland nut c a n lock
the cylinder. Leakage will not c e a s e immediately be­
c a u s e fluid h a s accumulated between the packing
and the gland nut. If the leakage persists, replace
the rod packing (Fig. 14).
SNOW PLOW FRAME
REMOVAL
(1) Support the snow plow frame.
(2) Remove the nuts and bolts that attach the
bumper brackets to the snow plow frame (Fig. 15).
(3) Remove the nuts and bolts that attach the sup­
port straps to the snow plow frame (Fig. 15).
(4) Remove the nuts, washers and bolts that attach
the snow plow frame to the vehicle frame side rails
and front crossmember (Fig. 15).
(5) Remove the snow plow frame and support from
the front of the vehicle frame (Fig. 15).
INSTALLATION
(1) Position and support the snow plow frame at
the front of the vehicle frame with the bolt holes
aligned (Fig. 15).
(2) Install the snow plow frame attaching bolts,
washers and nuts finger-tight (Fig. 15).
(3) Install the support strap attaching bolts and
nuts finger-tight (Fig. 15).
(4) Install the bumper bracket attaching bolts and
nuts finger-tight (Fig. 15).
(5) Tighten all the attaching nuts to 68 N-m (50 ft.
lbs.) torque.
(6) Remove the support from under the snow plow
frame.
SNOW PLOW PIWOT BRACKET
REMOVAL
(1) Support the snow plow pivot bracket.
' G L A N D NUT
PACKING
WASHER
WIPER P A C K I N G
POWER A N G L I N G CYLINDER
SPLIT BEARING
RN886
Fig. 14 Angling Cylinder—Exploded View