Chrysler RAM TRUCK 2500 1994 Service Manual page 235

6 - 2 CLUTCH
•
DAMPER
SPRINGS (5)
COVER
Fig. 3 V10 Engine Clutch Disc
J9406-9
FACING
MATERIAL
I DIESEL I
J9406-10
Fig. 4 Diesel Engine Clutch Disc
ter cylinder push rod. The switch is actuated by
clutch pedal movement. The clutch pedal must be
fully depressed i n order to start the engine.
The position switch is an integral part of the clutch
master cylinder push rod and is not serviced sepa­
rately.
Position switch circuitry is provided at the end of
this section (refer to Figure 10).
312.5 mm
(12.3 in.)
1DIESEL/V101
J9406-11
Fig. 5 V6/V8 Gas Engine Clutch Covet
COVER
281 mm
(11 in.)
PRESSURE
PLATE
rV67V8l
J9406-12
Fig. 6 VWDiesel Engine Clutch Cover
CLUTCH HYDRAULIC LINKAGE
The hydraulic linkage consists of a remote reser­
voir, clutch master cylinder, clutch slave cylinder and
interconnecting fluid lines (Fig. 8).
The clutch master cylinder is connected to the
clutch pedal and the slave cylinder is connected to
the clutch release fork. The master cylinder is
mounted on the drivers' side of the dash panel adja­
cent to the brake master cylinder.