Chrysler RAM TRUCK 2500 1994 Service Manual page 422

• INSTRUMENT PANEL AND GAUGES 8E - 26
SWITCH A N D P A N E L C O M P O N E N T S E R V I C E
INDEX
page
Cigar Lighter 27
Fuseblock Module
27
Glove Box 28
Glove Box Lamp Switch 26
Headlamp Switch 25
DISCONNECT NEGATIVE CABLE F E O M BAT-
TEEY I N E N G I N E COMPARTMENT BEFOHE
SERVICING I N S T R U M E N T PANEL.
HEATER A/C CONTROL
REMOVAL
(1) Remove cluster bezel (refer to Cluster Bezel Re­
moval).
(2) Remove 4 control attaching screws (Fig. 1).
Fig. 1 Heater—A/C Control Remowal
(4) Pull control rearward.
(5) Unplug 2 wiring harness connectors (Fig. 2).
(6) Push i n on red cable connector to release. Re­
move cable end from control unit.
(7) Remove control.
INSTALLATION
(1) Position control near panel.
(2) Connect control cables to control (see Heater
A/C Section).
(3) Connect illumination lamp, and wire connec­
tors.
page
Heater A/C Control 25
Inside Hood Release
27
Instrument Panel Replacement
28
Message Center Module 27
Overdrive Lockout Switch 26
Fig. 2 Heater—A/C Control Connections
(4) Push control into panel.
(5) Install 4 control mounting screws.
(6) Install cluster bezel.
HEADLAMP SWITCH
(1) Remove cluster bezel (refer to Cluster Bezel Re­
moval).
(2) Remove 3 screws and headlamp switch from in­
strument panel (Fig. 3).
Fig. 3 Headlamp Switch and Bezel Removal
(3) Unplug 2 electrical connectors (Fig. 4).