•
BUZZER WARNING SYSTEMS
8U - 5
1
RING
908D-16
Fig.
10 Unseated Key
Cylinder
Fig.
11 Key Cylinder
Removal
(4) Tilt column only—install tilt lever (clockwise).
(5) Install negative cable to battery.
(6) Install key cylinder as follows:
(a) With key cylinder and ignition in the LOCK
position, gently insert key cylinder into the ignition
switch assembly until it bottoms.
(b) Insert key, while gently pushing on key cylin
der inward toward the ignition switch, rotate key
clockwise to the ON position.
(7) Check for proper operation of push-to-lock, halo
lamp, ACCESSORY, LOCK, OFF, ON, START, col
umn lock and shift lock (if applicable).
BUZZER MODULE REPLACEMENT
(1) Disconnect negative cable from battery.
908D-18
Fig.
12 Ignition Switch—View
From
Column
Fig.
13 Ignition Switch Mounting
Pad
(2) Remove 5 screws and knee blocker from lower
instrument panel (Fig. 14).
Fig.
14 Knee
Blocker
(3) Remove 2 screws holding fuseblock module to
instrument panel (Fig. 15).
(4) Pull fuseblock module back far enough to gain
access to buzzer module.