Chrysler RAM TRUCK 2500 1994 Service Manual page 819

9 - 98 8.0L ENGINE
•
Fig. 3 Engine identification
CAUTION: DO NOT lift the engine by the intake
manifold.
(3) Install engine support/lifting fixture.
(4) Raise vehicle on hoist.
(5) Lift the engine SLIGHTLY and remove the
thru-bolt and nut (Fig. 4).
(6) Remove engine support bracket/cushion bolts
(Fig. 4). Remove the support bracket/cushion and
heat shields.
J9409-52
Fig. 4 Engine Front Mounts
INSTALLATION
(1) With engine raised SLIGHTLY, position the en­
gine support bracket/cushion and heat shields to the
block. Install new bolts and tighten to 81 N-m (60 ft.
lbs.) torque.
(2) Install the thru-bolt into the engine support
bracket/cushion.
(3) Lower engine with support/lifting fixture while
guiding the engine bracket/cushion and thru-bolt into
support cushion brackets (Fig. 5).
(4) Install thru-bolt nuts and tighten the nuts to
102 N-m (75 ft. lbs.) torque.
CUSHION
BRACKET
J9409-54
Fig. 5 Positioning Engine Front Mounts
(5) Lower the vehicle.
(6) Remove lifting fixture.
ENGINE REAR MOUNT
REMOVAL
(1) Raise the vehicle on a hoist.
(2) Position a transmission jack i n place.
(3) Remove support cushion stud nuts (Fig. 6).
Fig. 6 Engine Rear Support Cushion