8E - 12
i i S T i U i E i T PANEL AND IAUIES
•
Fig. 17 Voltmeter Terminals
(3) Check for continuity between
speedometer
speed sensor input terminal (Fig. 18) and ground.
There should be no continuity. I f OK, continue to
next step. I f not OK, repair short i n circuit from ve
hicle speed sensor.
(4) With ignition switch i n ON position, check for
battery voltage across speedometer B+ terminal and
ground terminal (Fig. 18). I f OK, replace speedome
ter/odometer. I f not OK, continue to next step.
(5) Unplug cluster connector B (black). With igni
tion switch i n ON position, check for battery voltage
at cavity #8. I f OK, continue to next step. I f not OK,
repair circuit to fuse #12.
(6) Turn ignition switch to OFF and unplug cluster
connector A (white). Check for continuity to ground
at cavity #6. I f OK, replace cluster printed circuit
board. I f not OK, repair open circuit to ground.
VEHICLE SPEED SENSOR
For testing of the vehicle speed sensor and related
components, refer to the Powertrain Diagnostic Test
Procedures manual.
TACHOMETER
When a problem occurs with the tachometer opera
tion, before disassembling the cluster to check the
gauge, check for a good tach signal from the power-
train control module (PCM). Refer to the Powertrain
Diagnostic Test Procedures manual for the appropri
ate tests.
(1) Pull instrument cluster from dash. Do not un
plug cluster connectors. Refer to Instrument Cluster
Replacement for removal procedures.
(2) Check continuity between PCM connector cav
ity 43 and tachometer input terminal (Fig. 19). There
should be continuity. I f OK, continue to next step. I f
not OK, repair open circuit as required.
(3) Check continuity between tachometer input ter
minal (Fig. 19) and ground. There should be no con-
J948E-32
Fig. 18 Speedometer
Terminals
tinuity. I f OK, continue to next step. I f not OK,
repair short i n circuit from PCM.
(4) With ignition switch i n ON position, check for
battery voltage across tachometer B+ terminal and
ground terminal (Fig. 19). I f OK, replace tachometer.
I f not OK, continue with next step.
(5) Unplug cluster connector B (black). With igni
tion switch i n ON position, check for battery voltage
at cavity #8. I f OK, continue to next step. I f not OK,
repair circuit to fuse #12.
(6) Turn ignition switch to OFF and unplug cluster
connector A (white). Check for continuity to ground
at cavity #6. I f OK, replace cluster printed circuit
board. I f not OK, repair open circuit to ground.
Fig. 19 Tachometer
Terminals