Chrysler RAM TRUCK 2500 1994 Service Manual page 281

7 - 2S COOLING SYSTEM
GENERATOR/COMPRESSOR
A N D BRACKET
SUPPORT BRACKET
I G N I T I O N
COIL BRACKET
Fig. 30 idler Pulley—3.9L ¥-6 or 5.2/5.9L ¥-8
LDC-Gas Engines
of the A/C compressor/generator bracket mounting
bolts. Remove the tensioner mounting bolt (Fig. 31)
and remove tensioner.
Fig. 31 Belt Tensioner—5.9L HDC-Gas Engine
(9) Remove the engine oil dipstick tube mounting
bolt at the side of the A/C-generator mounting
bracket.
(10) Disconnect throttle body control cables. Refer
to Accelerator Pedal and Throttle Cable i n Group 14,
Fuel System.
(11) Remove heater hose coolant return tube
mounting bolt (Figs. 32 or 33) and remove tube from
engine. Discard the old tube O-ring.
Fig. 32 Coolant Return Tube—3.9L ¥-6 or 5.2/5.9L
¥-8 LDC-Gas Engines
Fig. 33 Coolant Return Tube—5.9L HDC-Gas Engine
(12) Remove bracket-to-intake manifold bolts
(number 1 and 2 Fig. 29).
(13) Remove remaining bracket-to-engine bolts
(Figs. 33 or 34).
(14) Lift and position generator and A/C compres­
sor (along with their common mounting bracket) to