Chrysler RAM TRUCK 2500 1994 Service Manual page 200

•
ALL-WHEEL ANTILOCK BRAKE SYSTEM (ABS) 5 - 41
Fig. 10 ABS Valve Hydraulic Connections
Fig. 11 ABS Valve Mounting
ABS VALVE AND CONTROL MODULE
INSTALLATION
(1) Install replacement module on valve i f neces­
sary.
(2) Position ABS valve on mounting studs.
(3) Install and tighten mounting bolt and stud
nuts. Tighten bolts and nuts to 10-13 N-m (92-112 in.
lbs.) torque.
(4) Connect ABS harnesses to valve and electronic
module. Be sure module harness is securely latched
in place.
(5) Connect brakelines to ABS valve. Tighten line
fittings to 19-23 N-m (170-200 in. lbs.) torque.
(6) Install battery, i f removed.
(7) Fill and bleed brake system. Refer to procedure
in this section.
RWAL VALVE/COMBINATION ¥ALVE REMOVAL
(1) Disconnect ground wire and harness wires from
combination valve switch and RWAL valve (Fig. 12).
(2) Disconnect lines to front and rear brakes from
RWAL and combination valves (Fig. 13).
Fig. 12 Valve Harness Connector And Ground Wire
Locations
BRAKES J9405-82
Fig. 13 Master Cylinder Brakeline Removal
(3) Remove brakelines connecting master cylinder
to combination valve (Fig. 14).
(4) Remove nuts attaching master cylinder and
combination valve bracket to booster studs.
(5) Remove master cylinder.
(6) Remove combination valve, valve bracket and
RWAL valve as assembly.
(7) Remove brakeline connecting combination valve
to RWAL valve.
(8) Remove bolt attaching RWAL valve to combina­
tion valve bracket (Fig. 15). Then separate RWAL
valve from bracket.