Chrysler RAM TRUCK 2500 1994 Service Manual page 308

• COOLING SYSTEM 7 - 53
*IF VEHICLE IS N O T EQUIPPED WITH POWER
STEERING, THIS WILL BE A N IDLER PULLEY. J9307-26
Fig. 2 Belt Routing—3.9L V-6 or 5.2/5.9L V-8
LDC-Gas Engines
AUTOMATIC
TENSIONER
J9307-55
Fig. 3 Belt Routing—5.9L HDC-Gas Engine and 8.0 L
V-10—With A/C
(1) Attach a socket/wrench to pulley mounting bolt
of automatic tensioner (Fig. 7).
(2) Rotate tensioner assembly clockwise (as viewed
from front) until tension has been relieved from belt.
( 3 ) Remove belt from idler pulley first.
(4) Remove belt from vehicle.
AUTOMATIC
TENSIONER
J9307-56
Fig. 4 Belt Routing—S.9L HDC-Gas Engine and 8.0 L
V-10—Without A/C
•TOWER STEERING PUMP IS NOT BELT DRIVEN
Fig. 5 Belt Routing—5.9L Diesel Engine—With A/C
INSTALLATION
CAUTION: When installing serpentine a c c e s s o r y
drive belt, belt must be routed correctly. If not, en­
gine may overheat due to water pump rotating in
wrong direction. Refer to (Fig. 2) for correct engine
belt routing. The correct belt with correct length
must be used.