Chrysler RAM TRUCK 2500 1994 Service Manual page 424

•
INSTRUMENT PANEL AND GAUGES 8E - 27
MESSAGE CENTER MODULE
The message center is located i n the lower portion
of the heater control. Refer to Heater/A/C Control Re­
moval, i n this section.
FUSEBLOCK MODULE
(1) Disconnect negative cable from battery.
(2) Remove 5 screws and knee blocker from lower
instrument panel (Fig. 8).
Fig. 8 Knee Blocker Removal
(3) Remove 2 screws holding fuseblock module to
instrument panel (Fig. 9).
Fig. 9 Fuseblock Module Removal
(4) Pull fuseblock module back far enough to gain
access to buzzer module.
(5) Reverse removal procedure to install.
INSIDE HOOD RELEASE
REMOVAL
(1) Disengage cable from hood latch i n engine com­
partment.
(2) Remove 2 screws holding handle assembly to
instrument panel.
(3) Remove assembly by pulling cable rearward
through dash panel grommet.
INSTALLATION
(1) Feed cable assembly forward through dash
panel grommet.
(2) Mount handle assembly to instrument panel
with 2 screws.
(3) Connect cable to hood latch.
CIGAR LIGHTER
REMOVAL
(1) Remove 2 screws from cup holder (Fig. 10) and
remove cup holder assembly.
Fig. 10 Cup Holder Removal
(2) Remove 2 screws from ash receiver (Fig. 11)
and remove ash receiver assembly.
J948E-9
Fig. 11 Ash Receiver Removal
(3) Carefully pry bezel away from instrument
panel to disengage clips.
(4) Unplug connector from cigar lighter (Fig. 12).
(5) Unscrew cigar lighter from cluster bezel.
INSTALLATION
(1) Screw cigar lighter into cluster bezel.
(2) Plug connector onto cigar lighter.