8P - 4
POWER DOOR LOCKS
(4) Using a device such as a trim stick, pry trim
panel away from door around perimeter and remove
trim panel.
(5) Roll door watershield away from bottom of door
to allow access to lock motor (Fig. 6).
(6) Remove 3 screws holding lock motor and latch
assembly to door.
(7) Disconnect linkage rods.
(8) Pull motor and latch out far enough to unplug
electrical connector and remove moti ~ and latch from
door.
(9) To install a motor and latch, reverse the re
moval procedures. Tighten screws to 10.5 N*m (95 in.
lbs.).
J948P-3
Fig. 6 Lock Motor And Latch
Removal/Installation
i