Chrysler RAM TRUCK 2500 1994 Service Manual page 461

8H - 12 VEHICLE SPEED CONTROL SYSTEM
•
Fig. 3 Battery Heatshield
Fig. 4 Forward Battery Tray Nuts—Viewed From
Under Vehicle
(10) Pull speed control cable away from servo to
expose cable hairpin clip (Fig. 7).
(11) Remove hairpin clip attaching cable to servo.
(12) Pull servo away from mounting bracket.
INSTALLATION
(1) Insert servo studs through holes i n servo
mounting bracket.
Fig. 6 Speed Control Servo Mounting
(2) With throttle blocked to full open position,
align hole i n cable sleeve with hole i n servo pin and
install hairpin clip.
(3) Insert servo studs through holes i n cable
sleeve.
(4) Install 2 attaching nuts and tighten to 6 N-m
(50 i n . lbs.).
(5) Connect vacuum hose to servo.
(6) Connect electrical connector to servo terminals.