Chrysler RAM TRUCK 2500 1994 Service Manual page 146

•
REAR SUSPENSION AND AXLE 3 - 31
Fig. 36 Pinion Gear Depth Measurement
• Model 80: Remover D-159 and Handle C-4171
(9) Place depth shims i n pinion gear rear bearing
bore (Fig. 37). Install bearing cup with;
• Model 60 and 70: Installer D - l l l and Handle
C-4171
• Model 80: Installer C-4204 and Handle C-4171
INSTALLER
HANDLE
J9402-66
Fig. 37 Pinion Rear Bearing Cup Installation
(10) Install rear bearing (and slinger i f used) on
pinion gear (Fig. 38);
• Model 60: Installer C-3095A
• Model 70 and 80: Installer D-389
(11) Assemble preload shims or collapsible spacer
if used onto pinion and install pinion gear i n hous­
ing.
(12) Install pinion front bearing and oil slinger.
(13) Apply a light coating of gear lubricant on the
lip of pinion seal. Install the new seal with;
PRESS
DRIVE
PINION GEAR
SHAFT
REAR BEARING'
INSTALLATION
TOOL
DRIVE
PINION GEAR
OIL
SUNGER
J9302-68
Fig. 38 Pinion Rear Bearing Installation
• Model 60: Installer C-163
• Model 70 and 80: Installer D-187B
(14) Install yoke, washer and nut (Fig. 39).Model
60 and 70 install washer with concave surface
against the yoke. Install the yoke with;
• Model 60: Installer C-3716 and Holder 6719
• Model 70 and 80: Installer D-191 and Holder 6719
YOKE
INSTALLER
YOKE
HOLDER
J9402-61
Fig. 39 Pinion Yoke Installation