8G - 2
HORNS
•
(1) Unplug horn relay from connector inside PDC.
Plug in a known good relay. If horns stop blowing, re
lay is defective and must be replaced. If horns still
sound, replace original relay and proceed as follows:
(a) Connect one lead of test lamp to relay termi
nal 86 (battery) on the relay bank.
(b) Connect the other lead to relay terminal 85
(switch) on the relay bank. Should the lamp illumi
nate, either the wire from the horn switch is
shorted to ground or the horn switch is defective.
Continue to next step.
WARNING: BEFORE BEGINNING ANY AIRBAG SYS
TEM COMPONENT REMOVAL OR INSTALLATION,
REMOVE AND ISOLATE THE NEGATIVE (-) C A B L E
FROM THE BATTERY THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE
TO DO THIS COULD RESULT IN ACCIDENTAL AIR-
B A G DEPLOYMENT AND POSSIBLE INJURY
WAIT 2 MINUTES FOR THE RESERVE CAPACITOR
TO DISCHARGE BEFORE REMOVING OR WORKING
ON ANY AIRBAG SYSTEM COMPONENTS.
(2) Disconnect and isolate the battery negative ca
ble.
(3) Gain access to the horn switch connectors as
described in Horn Switch Replacement.
(4) Disconnect horn wires located in the lower por
tion of steering wheel.
(5) Repeat the previous test and if the test lamp
still illuminates, wire is shorted and should be re
paired. If test lamp does not illuminate, horn switch
is defective and must be replaced.
S E R V I C E P R O C E D U R E S
HORN SWITCH REPLACEMENT
WARNING: B E F O R E BEGINNING ANY A I R B A G S Y S
TEM COMPONENT REMOVAL OR INSTALLATION,
R E M O V E AND ISOLATE T H E NEGATIVE (-) C A B L E
FROM T H E BATTERY. THIS IS T H E ONLY S U R E
WAY TO D I S A B L E T H E A I R B A G S Y S T E M . F A I L U R E
TO DO THIS C O U L D R E S U L T IN A C C I D E N T A L AIR-
B A G D E P L O Y M E N T AND P O S S I B L E INJURY.
WAIT 2 MINUTES F O R T H E R E S E R V E CAPACITOR
TO D I S C H A R G E B E F O R E REMOVING OR WORKING
ON ANY A I R B A G S Y S T E M OOMPONENTS.
REMOVAL
(1) Disconnect negative cable from battery.
(2) From underside of steering wheel, remove
speed control switch mounting screws (Fig. 1), i f
equipped.
Fig. 1 Speed Control Switch
Removal
(3) Pull switches from wheel and unplug connector
(Fig. 2).
(4) Using a small screwdriver remove right rear
steering wheel cover (Fig. 3).
Fig. 3 Right Rear Steering Wheel
Cover